Files
1993eg1 7ed488bdfd Chamfer guide: remove the face-pick limit for Two Distances and Distance and Angle (#15678)
Tested in v0.40.1: picking a face and using Two Distances (2 mm / 1 mm) or Distance and Angle (2 mm, 30°) builds. The "chamfers ending at a concave corner" error the tip warned about is no longer in the code, so the tip is removed.
2026-11-12 22:43:05 +00:00

2.9 KiB
Raw Permalink Blame History

Cut a flat bevel along edges of a solid: the "break all edges" or "0.03 × 45°" callout on a print. You pick the edges and how the chamfer is sized.

Before you start

  • You need a solid body with edges to chamfer.
  • Pick edges one at a time, or click a face to chamfer every edge around it.
  • Chamfer edges before you add other features that touch them. An edge that already meets a small chamfer or fillet has little room left, and a chamfer there can fail.

Options

Choice in the dialog Meaning Example or reason to choose it
Edges The edges to chamfer. Click edges one by one, or click a face to take all of its edges. The four top edges of a block, or the top face.
Chamfer Type Equal Distance: the same leg on both faces. That is a 45° chamfer only where the faces meet at 90°. Two Distances: a different leg on each face. Distance and Angle: one leg and an angle. Equal Distance for a standard edge break on a square corner. Distance and Angle whenever the print gives an angle, like 0.06 × 30°, and for any chamfer on a sloped face.
Distance (Equal Distance) The leg length on both faces. 0.03 in for a typical edge break.
Distance 1 and Distance 2 (Two Distances) The leg on each face. 0.06 in by 0.03 in.
Distance 1 and Angle (Distance and Angle) The leg on the first face, and the angle off that face. 0.06 in at 45°.
Flip Swaps which face the first distance is measured on. Shown for Two Distances and Distance and Angle. Turn it on if the long leg ends up on the wrong face.
Tangent chain Follows the edge around smooth (tangent) bends, such as a fillet, so one pick chamfers the whole run. Leave it on for edges that flow into a fillet.
Preview Shows the chamfer on the part while you set it up. Leave it on.

Try it: break the top edges of a plate

  1. Make a 3 in × 2 in × 0.75 in block (sketch a rectangle, Extrude 0.75 in).
  2. Click Chamfer and click the four top edges. Edges shows 4 selected.
  3. Set Chamfer Type to Equal Distance and Distance to 0.03 in.
  4. Click OK. All four top edges have a 0.03 × 45° chamfer.
  5. To change it, edit the chamfer and set Chamfer Type to Distance and Angle, Distance 1 to 0.06 in and Angle to 30. Use Flip to swap which face takes the 0.06 in leg.

Tips and common mistakes

  • Do type the unit with the number when the print uses another unit. In a millimetre design, typing 0.03 in enters 0.762 mm.
  • Do chamfer all the edges of one size in a single Chamfer. It's one feature to change when the print changes.
  • Don't chamfer an edge right next to an existing small chamfer with a larger size. If the chamfer would run past the neighbouring face, the dialog says so; make the chamfer smaller or chamfer those edges together in one feature.

See also

{{#command solid.hole}} adds a countersink at the top of a hole. {{#command solid.fillet}} rounds an edge instead of beveling it.